Moritz Riede

Abstract:

Organic solar cells have the potential to become the cheapest form of electricity, beating even silicon photovoltaics. This article summarizes the state of the art in the field, highlighting research challenges, mainly the need for an efficiency increase as well as an improvement in long‐term stability. It discusses possible current and future applications, such as building integrated photovoltaics or portable electronics. Finally, the environmental footprint of this renewable energy technology is evaluated, highlighting the potential to be the energy generation technology with the lowest carbon footprint of all.

Abstract:

Stability is now a critical factor in the commercialization of organic photovoltaic (OPV) devices. Both extrinsic stability to oxygen and water and intrinsic stability to light and heat in inert conditions must be achieved. Triplet states are known to be problematic in both cases, leading to singlet oxygen production or fullerene dimerization. The latter is thought to proceed from unquenched singlet excitons that have undergone intersystem crossing (ISC). Instead, we show that in bulk heterojunction (BHJ) solar cells the photo-degradation of C₆₀ via photo-oligomerization occurs primarily via back-hole transfer (BHT) from a charge-transfer state to a C₆₀ excited triplet state. We demonstrate this to be the principal pathway from a combination of steady-state optoelectronic measurements, time-resolved electron paramagnetic resonance, and temperature-dependent transient absorption spectroscopy on model systems. BHT is a much more serious concern than ISC because it cannot be mitigated by improved exciton quenching, obtained for example by a finer BHJ morphology. As BHT is not specific to fullerenes, our results suggest that the role of electron and hole back transfer in the degradation of BHJs should also be carefully considered when designing stable OPV devices.

Abstract:

Simultaneous control over both the energy levels and Fermi level, a key breakthrough for inorganic electronics, has yet to be shown for organic semiconductors. Here, energy level tuning and molecular doping are combined to demonstrate controlled shifts in ionisation potential and Fermi level of an organic thin film. This is achieved by p-doping a blend of two host molecules, zinc phthalocyanine and its eight-times fluorinated derivative, with tunable energy levels based on mixing ratio. The doping efficiency is found to depend on host mixing ratio, which is explained using a statistical model that includes both shifts of the host's ionisation potentials and, importantly, the electron affinity of the dopant. Therefore, the energy level tuning effect has a crucial impact on the molecular doping process. The practice of comparing host and dopant energy levels must consider the long-range electrostatic shifts to consistently explain the doping mechanism in organic semiconductors.

Abstract:

The microstructure of organic small molecule (SM) layers in organic solar cells (OSCs) strongly influences device performance by impacting light absorption, charge transport, and recombination. We demonstrate that ellagic acid (EA), a naturally derived templating layer, induces substantial morphological and thus optoelectronic changes in the vacuum thermally evaporated (VTE) donor molecule DCV5T-Me(3,3). Using in situ grazing incidence wide-angle X-ray scattering (GIWAXS) during thin film deposition in the purpose-built MINERVA VTE chamber at Diamond Light Source, we show that a 5 nm EA layer reorients DCV5T-Me from an edge-on to a face-on molecular packing motif. This templating effect persists for up to around 90 nm of film thickness. Through UV–Vis spectrophotometry and photoluminescence (PL) spectroscopy, we observe a shift towards H-aggregation and decreased light absorption in the donor molecule with the EA template. Atomic force microscopy (AFM) shows that the donor morphology changes as a function of thickness from the donor-templating interface. In DCV5T-Me(3,3):C60 bulk heterojunction devices, the EA layer helps retain donor crystallinity and enhances short circuit current (J S C ), despite the lower absorption. Maximum power conversion efficiency in our devices is achieved with a 5 nm templating layer, which provides sufficient structural templating while maintaining partial interfacial contact for efficient charge extraction. We hypothesize that the improvement in J S C is likely driven by enhanced charge carrier dynamics due to the orientation change, shift towards H-aggregation, and change in growth mode.

Abstract:

Abstract Vacuum-deposited organic solar cells (OSCs) have lagged behind their solution-processed counterparts in achieving high power conversion efficiency (PCE), in particular as result of higher voltage losses. In this study, we demonstrate a bulk heterojunction OSC using SubNc as donor and DCV3T as non-fullerene acceptor, achieving a PCE of 2.6% and a remarkably low total voltage loss of 0.64 V, lower than the typical values exceeding 0.7 V observed in vacuum thermally evaporated fullerene-based systems. The device also exhibits non-radiative voltage losses comparable to leading non-fullerene-acceptor (NFA) based OSCs. Transient absorption spectroscopy confirms efficient Förster resonance energy transfer from DCV3T to SubNc, followed by electron transfer for exciton separation. Morphological Grazing Incidence Wide-Angle X-ray Scattering features suggest both blends have a preferential edge-on orientation of DCV3T molecules, and the blends with higher DCV3T content could suffer from suppressed out-of-plane lamellar crystallinity with possible connection with greater non-radiative losses. Our findings demonstrate the potential of designing low-voltage-loss evaporated OSCs by building on strategies from solution-processed NFA systems, while highlighting the continued need for new evaporable acceptors with optimised optoelectronic and morphological properties.