Prof Henry Snaith FRS

Abstract:

We present a combined experimental and theoretical investigation into the charge transport and recombination in dye-sensitized mesoporous TiO2. We electronically probe the photoinduced change in conductivity through in-plane devices while simultaneously optically probing signatures of the charge species. Our quasi-continuous wave technique allows us to build data sets of electron mobility and recombination versus charge density over a wide temperature range. We observe that the charge density dependence of mobility in TiO2 is strong at high temperatures and gradually reduces with reducing temperature, to an extent where at temperatures below 260 K the mobility is almost independent of charge density. The mobility first increases and then decreases with reducing temperature at any given charge density. These observed trends are surprising and consistent with the multiple-trapping model for charge transport only if the trap density-of-states (DoS) is allowed to become less deep and narrower as the temperature reduces. Our recombination measurements and simulations over a broad range of charge density and temperature are also consistent with the above-mentioned varying DoS function when the recombination rate constant is allowed to increase with temperature, itself consistent with a thermally activated charge-transfer process. Further to using the Monte Carlo simulations to model the experimental data, we use the simulations to aid our understanding of the limiting factors to charge transport and recombination. According to our model, we find that the charge recombination is mainly governed by the recombination reaction rate constant and the charge density dependence is mainly a result of the bimolecular nature of the recombination process. The implication to future material design is that if the mobility can be enhanced without increasing the charge density in the film, for instance by reducing the average trap depth, then this will not be at the sacrifice of comparably enhanced recombination and it will greatly increase the charge carrier diffusion lengths in dye-sensitized or mesoscopic solar cells.

Abstract:

A comprehensive study of various metal oxides in mesoporous and compact forms for electron injection in highly luminescent composite oxide-polymer light emitting diodes (COPLED) was presented. An improved performance with higher luminance and lower turn on voltage without O2 plasma treatment of the ITO prior to metal-oxide deposition is observed. It is found that the compact TiO2 performs considerably better than the mesoporous TiO2 and that the compact ZnO electron injection layer performs better than mesoporous and compact anatase. The higher current densities are due to leakage current through metal-oxide compact layers, and improvement of this deposition is found to increase the performance. Introducing a photonic structure into the metal oxide layers is found to enhance the optical out-coupling and electroluminescance efficiency.

Abstract:

We present a photophysical and device-based investigation of a new bipyridyl-NCS ruthenium complex sensitizer with an extended n system, in both sensitized TiO2 and incorporated into solid-state dye-sensitized solar cells. We compare this new sensitizer to an analog dye without the extended π system. We observe very similar excited-state absorption spectra and charge recombination kinetics for the two systems. However, the π-extended senstizer has a phenomenally enhanced molar extinction coefficient which translates into far greater light harvesting and current collection in solid-state dye-sensitized solar cells. We also infer from transient photovoltage measurements that positioning the pendent extended n system away from the TiO2 surface has induced a favorable dipole shift, generating enhanced open-circuit voltage. The resulting power conversion efficiency for the solar cell has been increased from 2.4% to 3.2% when comparing the new sensitizer to an analogy with no pendent group. © 2008 American Chemical Society.

Abstract:

We present a device based study into the operation of liquid electrolyte dye-sensitized solar cells (DSSC's) using organic dyes. We find that, for these systems, it is entirely necessary to employ a compact TiO2 layer between the transparent fluorine doped SnO2 (FTO) anode and the electrolyte in order to reduce charge recombination losses. By incorporation of a compact layer, the device efficiency can be increased by over 160% under simulated full sun illumination and more than doubled at lower light intensities. This is strong evidence that the more widely employed ruthenium based sensitizers act as to "insulate" the anode against recombination losses and that many planar organic dyes employed in DSSC's could greatly benefit from the use of a compact TiO2 blocking layer. This is in strong contrast to DSSC's sensitized with ruthenium based systems, where the introduction of compact TiO2 has only marginal effects on conversion efficiencies.

Abstract:

A new ion-coordinating ruthenium polypyridyl sensitizer, NaRu(4-carboxylic acid-4′-carboxylate)(4,4′-bis[(triethyleneglycolmethylether) heptylether]-2,2′-bipyridine)(NCS)2 (coded as K68), has been synthesized and characterized by 1H NMR, FTIR, UV-Vis absorption and emission spectroscopy. A power conversion efficiency of 6.6% was obtained for dye-sensitized solar cells (DSCs) based on the K68 dye and a newly developed binary ionic liquid electrolyte containing 1-propyl-3-methyl-imidazolium iodide (PMII) and 1-ethyl-3-methyl-imidazolium tetracyanoborate (EMIB(CN)4). For a non-volatile organic solvent based electrolyte, a photovoltaic power conversion efficiency of 7.7% was obtained under simulated full sun light and exhibited a good thermal stability during the accelerated test under 80 °C in the dark. Solid-state DSCs incorporating K68 also perform remarkably well, out-performing our previously best ruthenium complexes employed in this type of DSC. © 2007 Elsevier B.V. All rights reserved.