The Square Kilometre Array (SKA)

Abstract:

Aims. This paper discusses the spectral occupancy for performing radio astronomy with the Low-Frequency Array (LOFAR), with a focus on imaging observations. Methods. We have analysed the radio-frequency interference (RFI) situation in two 24-h surveys with Dutch LOFAR stations, covering 30-78 MHz with low-band antennas and 115-163 MHz with high-band antennas. This is a subset of the full frequency range of LOFAR. The surveys have been observed with a 0.76 kHz/1 s resolution. Results. We measured the RFI occupancy in the low and high frequency sets to be 1.8% and 3.2% respectively. These values are found to be representative values for the LOFAR radio environment. Between day and night, there is no significant difference in the radio environment. We find that lowering the current observational time and frequency resolutions of LOFAR results in a slight loss of flagging accuracy. At LOFAR's nominal resolution of 0.76 kHz and 1 s, the false-positives rate is about 0.5%. This rate increases approximately linearly when decreasing the data frequency resolution. Conclusions. Currently, by using an automated RFI detection strategy, the LOFAR radio environment poses no perceivable problems for sensitive observing. It remains to be seen if this is still true for very deep observations that integrate over tens of nights, but the situation looks promising. Reasons for the low impact of RFI are the high spectral and time resolution of LOFAR; accurate detection methods; strong filters and high receiver linearity; and the proximity of the antennas to the ground. We discuss some strategies that can be used once low-level RFI starts to become apparent. It is important that the frequency range of LOFAR remains free of broadband interference, such as DAB stations and windmills. © 2012 ESO.

Abstract:

A few binary systems display High Energy (100 MeV-100 GeV) and/or Very High Energy (≳ 100 GeV) gamma-ray emission. These systems also display non-thermal radio emission+that can be resolved with long-baseline radio interferometers, revealing the presence of outflows. It is expected that at very low frequencies the synchrotron radio emission covers larger angular scales than has been reported up to now. Here we present preliminary results of the first deep radio observations of the gamma-ray binary LS I +61 303 with LOFAR, which is sensitive to extended structures on arcsecond to arcminute scales. © 2012 American Institute of Physics.

Abstract:

Here we present the design and performance of a novel unilateral finline Nb-AlOx-Nb SIS (Superconductor-Insulator-Superconductor) mixer, operating around 230 GHz, with a target IF bandwidth of 2-13 GHz. The mixer is intended to be used in GUBBINS [1], a prototype high brightness sensitivity, low spatial resolution heterodyne interferometer. A key feature of the mixer design is the use of a unilateral finline taper to provide a smooth transition from high-impedance waveguide to low-impedance microstrip suitable for feeding a 1μm2 SIS junction. The use of a finline transmission line allows other complicated planar circuits to be compactly integrated on the substrate and allows the use of an easy-to-fabricate mixer block. Also the employment of the silicon substrate allows trenches to be fabricated around individual SIS mixer devices on the wafer, allowing the devices to be separated easily without dicing. To realise the wide IF bandwidth, a separate IF matching board, consisting of a few sections of microstrip, was designed to match the dynamic output impedance of SIS mixer to the LNA. In this paper, the SIS mixer design will be described in detail, including the electromagnetic simulations of the passive circuit with HFSS. We have fabricated and tested several of these SIS mixers over RF bandwidth 190-260 GHz. We have obtained a best noise temperature of 75 K at 208.8 GHz over IF bandwidth 4-6 GHz. However, the noise temperature measured across IF bandwidth 2-18 GHz shows that an IF resonance exists around 8 GHz, caused by an excess capacitance due to the large surface area of the microstrip transition and RF matching circuitry. An improved design is described, suitably modified to shift the IF resonance out of the target IF band.