The Oxford 3D thermophysical model with application to PROSPECT/Luna 27 study landing sites
Planetary and Space Science Elsevier 182:March 2020 (2019) 104790
Abstract:
A 3D thermal model that includes a discrete subsurface exponential density profile, surface shadowing and scattering effects has been developed to simulate surface and subsurface temperatures across the Moon. Comparisons of the modelled surface temperatures with the Lunar Reconnaissance Orbiter’s Diviner Lunar Radiometer Experiment (“Diviner”) measured temperatures show significant improvements in model accuracy from the inclusion of shadowing and scattering effects, with model errors reduced from ~10 K to ~2 K for mid-latitude craters. The 3D thermal model is used to investigate ice stability at potential landing sites near the lunar south pole, studied for Roscosmos’ ‘Luna Resource’ (Luna 27) lander mission on which the ESA PROSPECT payload is planned to fly. Water ice is assumed to be stable for long periods of time (>1 Gyr) if temperatures remain below 112 K over diurnal and seasonal cycles. Simulations suggest ice can be stable at the surface in regions near to potential landing sites in permanently shaded regions and can be stable below the surface in partly shaded regions such as pole-facing slopes. The simulated minimum constant subsurface temperature (where the seasonal temperature cycle is attenuated) typically occurs at a depth of ~50 cm and therefore the minimum depth where ice can be stable is A 3D thermal model that includes a discrete subsurface exponential density profile, surface shadowing and scattering effects has been developed to simulate surface and subsurface temperatures across the Moon. Comparisons of the modelled surface temperatures with the Lunar Reconnaissance Orbiter’s Diviner Lunar Radiometer Experiment (“Diviner”) measured temperatures show significant improvements in model accuracy from the inclusion of shadowing and scattering effects, with model errors reduced from ~10 K to ~2 K for mid-latitude craters. The 3D thermal model is used to investigate ice stability at potential landing sites near the lunar south pole, studied for Roscosmos’ ‘Luna Resource’ (Luna 27) lander mission on which the ESA PROSPECT payload is planned to fly. Water ice is assumed to be stable for long periods of time (>1 Gyr) if temperatures remain below 112 K over diurnal and seasonal cycles. Simulations suggest ice can be stable at the surface in regions near to potential landing sites in permanently shaded regions and can be stable below the surface in partly shaded regions such as pole-facing slopes. The simulated minimum constant subsurface temperature (where the seasonal temperature cycle is attenuated) typically occurs at a depth of ~50 cm and therefore the minimum depth where ice can be stable is 0Evidence for ultra-cold traps and surface water ice in the lunar south polar crater Amundsen
Icarus Elsevier 332 (2019) 1-13
Abstract:
The northern floor and wall of Amundsen crater, near the lunar south pole, is a permanently shaded region (PSR). Previous study of this area using data from the Lunar Orbiter Laser Altimeter (LOLA), Diviner and LAMP instruments aboard Lunar Reconnaissance Orbiter (LRO) shows a spatial correlation between brighter 1064 nm albedo, annual maximum surface temperatures low enough to enable persistence of surface water ice (<110 K), and anomalous ultraviolet radiation. We present results using data from Diviner that quantify the differential emissivities observed in the far-IR (near the Planck peak for PSR-relevant temperatures) between the PSR and a nearby non-PSR target in Amundsen Crater.We find features in far-IR emissivity (50–400 μm) could be attributed to either, or a combination, of two effects (i) differential regolith emissive behavior between permanently-shadowed temperature regimes and those of normally illuminated polar terrain, perhaps related to presence of water frost (as indicated in other studies), or (ii) high degrees of anisothermality within observation fields of view caused by doubly-shaded areas within the PSR target that are colder than observed brightness temperatures.
The implications in both cases are compelling: The far-IR emissivity curve of lunar cold traps may provide a metric for the abundance of “micro” cold traps that are ultra-cool, i.e. shadowed also from secondary and higher order radiation (absorption and re-radiation or scattering by surrounding terrain), or for emissive properties consistent with the presence of surface water ice.
Publisher Correction: Craters, boulders and regolith of (101955) Bennu indicative of an old and dynamic surface
Nature Geoscience Springer Nature 12:5 (2019) 399-399
Craters, boulders and regolith of (101955) Bennu indicative of an old and dynamic surface
Nature Geoscience Springer Nature 12:4 (2019) 242-246
Abstract:
Small, kilometre-sized near-Earth asteroids are expected to have young and frequently refreshed surfaces for two reasons: collisional disruptions are frequent in the main asteroid belt where they originate, and thermal or tidal processes act on them once they become near-Earth asteroids. Here we present early measurements of numerous large candidate impact craters on near-Earth asteroid (101955) Bennu by the OSIRIS-REx (Origins, Spectral Interpretation, Resource Identification, and Security-Regolith Explorer) mission, which indicate a surface that is between 100 million and 1 billion years old, predating Bennu’s expected duration as a near-Earth asteroid. We also observe many fractured boulders, the morphology of which suggests an influence of impact or thermal processes over a considerable amount of time since the boulders were exposed at the surface. However, the surface also shows signs of more recent mass movement: clusters of boulders at topographic lows, a deficiency of small craters and infill of large craters. The oldest features likely record events from Bennu’s time in the main asteroid belt.Evidence for widespread hydrated minerals on asteroid (101955) Bennu
Nature Astronomy Springer Nature 3:4 (2019) 332-340